|
|
|
[700x520] [2080x1544]
Stand fitted before adjustment. Material needs to be removed from front and back. If your stand is worn less material need be removed
|
[700x520] [2080x1544]
fitting the stand requires removing material so the stand will go forward and fully retract. We left extra material for this reason
|
[700x520] [2080x1544]
propstand lug after removing material to get the amount of movement desired. We left extra material so you could adjust for a worn original stand
|
Album: Untitled Last change: 10/24/11
Contains: 1 item.
|
[700x520] [2080x1544]
Position the lug so the bike leans at a slight angle when the stand is down. Tack weld the lug on both sides of the lug center
|
[700x520] [2080x1544]
The lug is tack welded on both sides. Check the lean angle of the machine to be sure this is where it needs to be
|
[700x520] [2080x1544]
Heat the upper arm of the lug and bend around frame using a hammer. The material is very easy to form when heated
|